Opaquer

Material Safety Data Sheet

Identity: ADHERENCE MULTI-CURE M5 COMPOSITE SYSTEM  - Opaquer

SECTION l

Manufacturer:                                                                                                      Confi-Dental Products Co.

Address:                                                                                                              1315 E. 500 N., Anderson, IN 46012

Emergency Telephone Number:                                                                           

Telephone Number for information:                                                                 1-765-643-1061

Date Prepared:                                                                                                     12/05/2006

SECTION II- Hazardous Ingredients

     Hazardous Components :As defined by DFR 1910, 1200     NIA - Contains Bls-GMA and ethoxylated derivative,

         Polyethylene glycol dimethacrylate, Amine, Keytone Photolniator, Opaque Pigments, inorganic color tints

SECTION III- Physical Data

Boiling Point: N/A

Vapor Pressure (9 mm Hg.: N/A

Vapor Density (Air = 1): N/A

Specific Gravity (Water = 1): N/A

Melting Point: N/A

Evaporation Rate (Butyl Acetate 1): N/A

Solubility in Water: Insoluble

Appearance and Odor: Color dependent on tinting, slight fishy odor

SECTION IV - Fire and Explosion Data

Flash Point (Method Used): Will not burn

Flammable Limits: N/A

Extinguishing Media: N/A

Special Fire Fighting Procedures: None

Unusual Fire and Explosion Hazards: None

SECTION V - Reactivity Data

Stability: Stable

Incompatibility (Materials to Avoid): Peroxides

Hazardous Decomposition or By-Products: N/A

Hazardous Polymerization: Avoid exposure to light and excessive heat

SECTION VI - Health Hazzard Data

Routes of Entry:

inhalation?: N/A

skin?: May cause skin irritation

ingestion?: N/A

Health Hazards (Acute and Chronic): Prolonged contact may cause skin and eye irritation

Carcinogenicity: N/A

Signs and Symptoms of Exposure: Skin redness

Medical Conditions Aggravated by Exposure: None Known

Emergency and First Aid Procedures: If skin is contacted, wash off with soap and water.

SECTION VII- Precautions for Safe Handling and Use

Steps to Be Taken In Case Material Is Released or Spilled:    Wipe up with absorbent material

Waste Disposal Method:    Dispose of In accordance with federal, state and local regulations.

Precautions to Be Taken in Handling and Storing: Store in temperatures under 75 degrees F. and avoid contact with skin and eyes

Other Precautions: N/A

SECTION VIII- Control Measures

Respiratory Protection: Not needed

Ventilation: Not needed

Protective Gloves: Recommended

Eye protection: Place glasses over patients eyes to avoid accidental eye contact with material

and light activated polymerization method.