Ceram-Etch

Material Safety Data Sheet

Identity:     Ceram-Etch

SECTION l

Manufacturer:                                                         GPI

Address:                                                                  13391 Murphy Road, Stafford, TX 77477

Emergency Telephone Number:                         800-527-3250                                         

Telephone Number for information:                 1-765-643-1061

Date Prepared:                                                        5/14/2007

SECTION II- Hazardous Ingredients

Hazardous Components :As defined by DFR 1910, 1200     Hydrofluoric acid - 9.5%

SECTION III - Physical Data

Boiling Point:  212 F.- 246 F.

Vapor Pressure (9 mm Hg.:  9-10 @ 25° C

Vapor Density (Air = 1):  1

Specific Gravity (Water = 1):  1.8

Melting Point: n/A

Evaporation Rate (Butyl Acetate 1): 1

Solubility in Water:  ACID CINTENTS 100%

Appearance and Odor:  PINK, VERY LITTLE ODOR

SECTION IV - Fire and Explosion Data

Flash Point (Method Used):  Will not burn

Flammable Limits:  N/A

Extinguishing Media:  N/A

Special Fire Fighting Procedures:  None

Unusual Fire and Explosion Hazards:  None

SECTION V - Reactivity Data

Stability:  Stable

Incompatibility (Materials to Avoid):  N/A

Hazardous Decomposition or By-Products:  N/A

Hazardous Polymerization:  Will not occur

SECTION VI- Health Hazard Data

Routes of Entry:

inhalation?:  Yes

skin?:  Yes

ingestion?:  Yes

Health Hazards (Acute and Chronic):  Prolonged breathing of fumes may cause lung damage

                                                             May cause redness or burning

                                                             Eye contact may cause burning

Carcinogenicity:  N/A

Signs and Symptoms of Exposure:  Redness, burning sensation

Medical Conditions Aggravated by Exposure:  N/A

Emergency and First Aid Procedures:  Skin: flush with water. Eyes: flush with water for 15 minutes,

consult with physician. Ingestion: Do not ind7uce vomiting, give large amounts of water containing milk of magnesia, milk or olive oil.

SECTION VII- Precautions for Safe Handling and Use

Steps to Be Taken in Case Material is Released or Spilled:     Flush area with water.

Waste Disposal Method:     Neutralize with soda ash or lime and dispose of In

                                                    accordance with federal, state and local regulations.

Precautions to Be Taken in Handling and Storing: Rubber gloves are recommended.

Other Precautions: Protective glasses should be worn. Store in a cool area out of direct sunlight

SECTION VIII- Control Measures

Respiratory Protection:  Use in a ventilated area.

Ventilation:  No special exhaust system needed.

Protective gloves:  Rubber gloves should be worn.

Eye protection:  Wear protective glasses or eyewear.